View Full Version : Technical Discussion
- Has This Ever Happned to You?
- Non liquid Carb sync tool, What is your favorite?
- Dies Under Hard Braking
- Poor gas milage.
- Swing arm bearing placement reassemble.
- Gauges died and then bike died - charging system?
- Dead Spot Help!!
- Starter relay failure
- MCCT Clanking?
- What Happens?
- Random Vaccum Hose from Rear Carb
- replacement fuel screw O ring
- Knocking noise at idle
- Starts, runs great. Warms up and dies intermittently.
- Rear Brake Pad Change - Pad Pin Stuck
- Headlight quit, need guidance
- Headlight relays, HID headlight and a delay
- runs horrible over 5000 rpm
- Air Filter - Honda vs Emgo
- Fuel light help
- Instrument Panel/Electrical Issue
- Coil on cap redo
- Rear turn signal(s) not working
- Electrical Problems - Harness Melted
- bike dies at light
- Clutch Slave/Push rod
- Tach fritzing
- Carb sync - Idle set - Idle drop - Video Inside
- suspension
- Carb parts falling out.
- Quick water pump question
- Under tray lock broke. Can't get my seat off!
- Exhaust cap
- high Rev, low power
- Afraid to ride in the dark...
- mosfet r/r install roadstercycle?
- frame sliders
- Spark plugs?
- Having trouble with front brake pad pin hanger caps...
- VTR knocking noise
- Carb Sync Question
- Head shake
- Jet Kit Recommendations
- Chain hitting exhaust?
- Front flushmount led turn signals wont blink.
- What's inside
- Gas tank sensor
- neutral light?
- Slow turn signal fix.... the obvious method
- Help with this water line
- Free power ground mod
- Not a tire thread
- Clunk then cuts off?
- R/R, stator, ground connection help
- Stuck Carb sliders
- 04-05 GSXR 600 GSX R600 FRONT FORK ASSEMBLY
- Diagnostic
- can manual cct's increacse idle speed
- CCT re-adjust question
- Anyone TIG Weld Aluminum & want to help with a Superhawk project?
- Fork brace and seal leaks
- Is your shifting sloppy?
- 99 sprhawk Only one cyclinder running other wont even manual crank around help please
- Engine sounding different after CCT installation?
- flat spot
- My Journey Into the Heart of The VTR
- Cleaned carbs, won't start...
- Stock CCT removal info
- Anybody know what the stock rebound shim stack spec of the stock forks?
- Steering Stem bearings won't fit in new frame
- OEM CCT replacements
- Clock settings
- Engine quits while at idle
- New member considering CCT replacement
- clutch not disengaging?
- integrated tail light issue
- CV slide flutter?
- CCT Failure and Bent Valves
- Choke Assembly
- Motor Work
- Valve Adjustment Tolerance - Consensus?
- Valve shimming at what milege intervals ??
- "Bogs" at 6-7krpms and "miss"
- Castle Nut Tool for the frame
- Tighten your Nuts and Bolts!
- LiOn battery charging rate
- Starting with cold engine - Enrichener questions
- Wont start and wont stay running
- No spark at front or rear spark plugs.
- shock linkage
- speedo and odometer inop....confused.
- Mosfet R/R problem ?
- Fork Removal
- torque values
- Rear Head machined for Front Cylinder
- Too good to be true?
- Lithium back up battery arrived
- Bit of help please from the technical minded, not SH
- Rear Shock Safewty Warning
- Will shimming my carb needles fix this?
- Intermittent low rpm issues
- O2 aftermarket gauge?
- Valve clearance feeler gauge
- Fitting a Steering damper
- Engine Stand - Home Made How-To
- PAIR system vacuum feed question
- Larger, front mounted Oil cooler
- Retrofit Shroud Fell Off
- 98 Superhawk runs a minute then dies
- eBay brake rotors?
- Back Brake
- Help me
- front axle hole
- Temp drops when it's cold or rainy, bike runs badly. I'm stumped..
- Ok to run different tires?
- Can someone show me what the stock linkage should look like?
- Coil on cap questions
- CCT question
- Header Colour(Color)
- Spark Plug Removal
- Exhaust swap - GSXR, R1 ?
- fuel tanks???
- Removing the Sub Gear (a.k.a. Anti Rattle Gear)
- Carb Cleaning Question
- Engine ticking noise
- One exhaust getting hotter+popping
- Homemade jump starter?
- Rescued fellew biker
- Random shut down?
- pleaseeee help me.. engine turns but dont start :((((
- water pump weep hole
- charging issues (beating a dead horse, maybe?)
- Crash rebuild
- Tire issue
- All gauges stopped working.
- Starting Issue - Neutral Switch Mystery
- Electrical Help Needed
- Main fuse blown after mofset??
- Camshaft question
- Swingarm pivot size?
- Rear ride height
- What needle is this?
- Carb Questions, Yet again...
- engine building and break in.... Myths?
- vtr overheating again -_-
- Electrical Help Please
- Sproket
- Clutch Master cylinder, cant get in gear. please help
- Mr. Gasket #9748 Fuel filters
- Back brake failing... Ready to take it to the dealer... Help?
- Issues with manual CCT change.
- Lost in a PAIR nightmare
- dead battery and stalled VTR
- Rattling noise from rear cylinder at idle
- poor gas milage
- Clutch master cylinder assembly
- Super Sprox Counter Shaft Question
- Buzz Kill
- different size front tire spacers?
- What's that clickin noise?
- This is a dumb question but need help
- Should oil be there?
- Cooler spark
- Odd clicking when entering the powerband
- Alternator cover removal question
- Exhaust Header normal?
- No Power After Click
- How to change rear brake fluid without removing cover
- Name that fork!
- No fuel to rear carb
- tach sensor?
- fuel gauge fluctuating
- clicking in carb intake
- any suggestions
- Is there anything from a Dynojet kit worth having?
- Quickturn throttle, I want more....
- New front brake rotors?
- OEM CCT question
- New R/R, dead bike... where do I look?
- Engine Shuts down suddenly no lights and no electrical -Totally dead
- It doesnt like the rain
- Standard Fork Upgrade Service Guide
- Lower fairing mounting bracket
- Plug n' Play Rectifier/Regulator
- Replacement batteries
- One turn signal blinks too fast!
- mcgyver rear amber running lights
- Brake Pad Replacement
- Can somebody measure there spark plug socket for me?
- rear turn signals odd behavior
- Cluster issue
- cct replacement
- Coerce rear sets
- good news and bad news
- Laid her down, but oh so gently!
- RR Fork question
- Suspension settings with 1000rr front end swap.
- Stripping... and not in a good way
- Speedometer suddenly not working
- Tail Lightbulb upgrade?
- Trick to Quiet Two Brothers Cans
- Sloppy second shift
- F4i rear shock question
- Swing arm pivot nut
- Are two mounts really necessary for stock cans?
- Front turn signals
- Rear brake master cylinder trouble
- 98 superhawk headache
- Daily Battery Tender Jr. Use?
- bigger oil cooler causes lack of oil?
- VTR TROUBLES WAH!
- Cct correct?
- is this a "fart"?
- Oil In Airbox
- K&N filters.
- Electrical questions!
- HISS ?
- Swapped in the 2008 CBR1000rr front end...It is possible!
- Consequences of returning to stock exhaust
- Over heating 98 VTR1000
- the tear down begins
- Very specific California carb & EVAP question with photo
- maxifuse or circuit breaker
- Low idle and engine cuts off at stops
- Stock exhaust mounting tab question
- Ohlins set up.
- Needle Holder / Valve Plate O Rings
- Cut off, low idle won't stay on.
- Converter unit wires
- voltage regulator rectifier
- carb balancing
- Electrical problems
- Rear Brake feels sticky
- Gearing for acceleration
- dynojet kit removal
- clip ons
- Spark problems
- one tooth off?
- bike cutting out
- cams
- Lightened flywheel and no cush drive. Good idea?
- Which colour wire is the speed pulse?
- No turn signals working
- Cant get my fuel screws out?
- Hawk running troubles
- The finer points of cowl "body clips"?
- Bolts sheared off slave cylinder - HELP
- 929 stick coils fit the Superhawk?
- New chain time, 520 or 530?
- steering head bearings