View Full Version : Technical Discussion
- Help finding part number?
- Rebuild and possible mods - opinions welcome
- Low beam and High beam out - What bulb do you recommend?
- Speedometer Errors
- Ignition switch removal
- Repair Manual
- Auto CCT
- Electric help-speed sensor
- instrument panel dead
- How to check for cam chain wear?
- cam align verification!!40 hrs torn apart! time to put back together :)
- Honda HP4 Oil change kit.. less than advertised capacity?
- 1st-2nd Gear Shift Issue/Neutral Pop
- Emulsion tubes mixed up
- Temp gauge not working / fan too?
- Wet bike, No Tach
- Sag settings
- Front brakes pulsing?
- Counterfiet air filter(?)
- steering head bearings
- No Power, not getting enough fuel?
- So.....
- 2002 Superhawk dropping a cylinder?
- front sprocket casing?
- No break light.
- Dunlop Q3's
- Any good way to lift front without stand?
- top end misfire
- Carb Slide Question
- CBR600f4i 2002 Fan kicks whenever in neutral
- rectifier
- clutch slipping
- Wheel Bearing PN?
- Fuel gauge not working
- New Tire Leaking at the Bead
- Need help - can't remove bar ends
- Fuel pouring out of front carb
- CBR1000 Sidestand yrs
- Fork oil change HELP!!!!
- HELP! No Headlight!
- Petcock Re-assembly
- Bike dying at idle when hot
- How to remove oil filter?
- Tire Week by Dave Moss
- Tire pressure by Dave Moss
- Battery cable replacement question
- 1998 VTR runs rough at high rpm under a load
- Castrol GTX synthetic blend ok?
- Turn Signal woes...Right side won't blink
- Coerce Racing sprocket guard Vs OEM
- Bike won't start any more.
- Timing
- riding to high altitude
- Jumping out of second gear
- Front fairing stay measurements
- Regulator/rectifier
- Setting up the stock suspension
- Turn signal quandry
- Tear down
- Carbs, again? Say it isn't so.....
- Setting SAG not possible???
- Clarify TPS setting please, I need a clue...
- Help getting to carb slide needle
- Help me identify these carb hoses plz
- low eng pwr/new eng ticking
- Advice: The bike has sat for a year w/gas
- New bike 1998 VTR100 lean or rich?
- rr smoking???
- Quick header wrap 1 cylinder question
- Temp Differential From Exhaust?
- Ticking Sound: Share your oppinion
- Gamble on the CCT'S?
- very frustrated
- Clutch problem - Please help!
- How to guide: Fix flashing speed of LED indicators
- Dyno Questions
- STOCK SHOCK
- more comfortable bars instead of stock? :(
- GPS tracker?
- Ah. This can't be good news... help?
- Street tires and sizes question for sturdy street riding
- syncing carbs, rear slide stuttering ??
- Radiator fan assembly
- cough at 3500RPM
- Boost joint?
- dampening adjustment
- newb doing a valve adjustment...
- oil leak
- Engine Knocking???CCT?
- I read this on forums.sportrider.com
- CCT Issue
- Bike cutting out when hot.
- Fairing installation
- Attempting to replace mechanical - questions
- Carb Sync
- CArburator? know a good mechanic in San diego..??
- Hoping for an assist in SC
- Dyno Result
- front sprocket and rear sproket torue?
- Fine Tuning Carb Q.
- running on 1 cylinder.. .or so i assume
- Shawk length
- Weird kick?
- Think its My RR
- Cooling fan help/ideas?
- 1998 Superhawk that wont start unless jumped
- New to SH and looking for advice
- Running hotter and using more fuel
- VTR1000f Converter box
- Is it faulty rectifier?
- Another CARB set up thread
- bike wont start
- I think conrod is broken....
- missfire after warming
- Does Your Hawk Surge
- Camshaft timing marks reference
- Picked up a screw with front tire...
- Valve spring removal
- She is not running right after the accident, loosing rear cylinder
- Quick Carb Synch Question
- OEM CCT Replaced
- Which wires for turn signals?
- Oil drain plug bolt thingy
- Rotor clearance question, real quick
- Valve adjustment
- Where do these two hoses go?!
- Brake pad upgrade and SS lines
- Please help again!
- Markus, what do u think of these?
- Clicking sound on my hawk (new to forum)
- Fuel filter
- Changing CCTs
- Superhawk Spark Plug Removal
- OEM Tool-Kit Question
- R/R installed...Now lost right rear brake and turn signal...
- ALERT: STOLEN RED 1998 SUPERHAWK
- Hiccup while cruising.
- Bikes dead please help!
- Just A Heads Up
- Carb Question (yes I used search)
- Regulator Swap...ground location
- Sticking Headlight switch
- Chain and sprockets?
- Front Wheel Removal Assistance
- What to do ????
- The hits just keep on comin....
- Clutch Cover Query
- Fuel screw search
- Bike doesn't want to run past 7000rpm
- Idles fine runs like crap
- Where does it go?
- MWR ?
- NEED help with wiring!
- Riddle me this: Intake valves way out of spec
- Camera mount locations less vibration?
- gas leak?>
- Some days life just works
- OEM Brake Rotor Thickness
- Motion Pro Revolver - Possible?
- Whats The Deal With The CCT'S
- Hugger fitment with different tire
- Jetting Carbs
- Stupidity causes MCCT failure, potential damage?
- Carbs spewing gas
- Rear tire size for the Superhawk
- Question about clutch slippage
- New Carb starter valve retainer
- Shim-shim-how many?
- Bike is dead
- R/R Question
- strange electrical event
- Whar size is the socket to remove clutch basket?
- Bar end weights
- front brake lines
- Stalling problems
- VTR running rough
- Zener Diode in ignition?
- 98 VTR1000 Fuel/Electronics/Both?
- Ambient temp on dash mod
- Track day electrics
- Space age moto tech
- Color Codes?
- petcock diaphragm
- UH OH!!
- Projector headlight wiring
- sync the carbs
- 530 Chain link when gearing
- Recently developed low rev miss
- Rebuild kit
- Swingarm nut size
- Need new thermostat - any suggestions?
- fuel injection
- Dynojet Installation
- annoying backfire through carburetors
- "Vapor Lock"
- Hi all I have a question about alarms...
- Vista Cruise Throttle Lock
- Brake/tail light malfunction
- front fork spring rates.
- Jack wagon did a real number on my electrical system
- Questions on my new 98 Super Hawk
- First Valve Adjustment at 67k miles
- Maintenance Items & Issues
- Fork tube compatibility question
- Ahhh, winter work...
- bike shuts down on its own
- air adjustment screw tool
- rear cylinder missfireing
- finally balanced my carburetors
- rear shock modification
- Fluids to flush
- Replacing Clutch Lever
- New Chain and Sprocket
- Anyone used "Hot Cams" shims?
- carb running issues
- Utah Riders/Mechanics and CCT problems
- Exhaust questions
- Hazard Fraught tools
- that damn little screw!
- air adjustment screw
- temp gauge and rad fans
- tacho not working properly
- Repacking an Aluminum Leo Vince SBK muffler
- RT Piston
- Ethanol removal
- Transporting a SH
- Mid-pipes might work-got any?
- Getting Frame Sliders
- Loud horn
- Wheel Bearings...
- Interval for MCCT adjustment?
- Playing with batteries...
- Front Axle Collar Dimension CBR 1000 RR
- Replacing the clutch lever
- flat spot
- Yoshimura Dual Carbon Fiber exhaust pipes.
- Cost getting Carbs cleaned
- Overheated in 60 degree weather?? Need help guys.
- Replacing Lost Keys
- missfire
- Primer question
- Need help with valve clearance RT and FT position
- Mcct help/questions
- Quick PVLIR Question & K&N
- Chain and Sprocket advice
- Will R6 shock fit Hawk?
- Knock, Stall and Backfire through the rear carb
- Cost of Parts and Labor on a CCT replacement on a 1998 SH
- Possible Transmission Problem?
- Speedo only works when engine braking!