View Full Version : Technical Discussion
- Question for the wrenches
- Pirelli scorpion sync experience?
- replaced RR with GSXR unit do these voltages sound right?
- Another clutch thread - fluid and air
- Front mounted radiator questions
- Frontend swappers rads move query
- conti road attack
- Q for Hawkrider and others with 1000RR experience
- Strange clicking/ticking sound
- How do you guys get that dang D idle screw out?
- ?? leaky brake bleed nipple?
- Radiator leak
- Feedback on Tire Changers
- RC51 WHATS THE DIFFERENCE BETWEEN 02-03 TANKS?
- any other Vegas members
- Fuel Stabilizer screw up?
- Electrical help PLEASE?
- CBR wheel combo, which bearings?
- Another starting issue
- high speed stability?
- Wheel Identification
- Carb queston
- changing tyres
- APE CCT's
- CBR vs RC51 front wheel
- SHOCKing discussion!
- Race tech or frontal swap??
- Front sprocket rubber seal? tossit or save it?
- Horsepower and Torque?
- Manually adjusting APE CCTs
- Last Q....vibe + CCT noise, related?
- in the midst of MCCT install
- front fork springs ? & recomendations
- RLOD Replacement
- Should I even bother tuning now?
- Melting Cluster ?
- Need suggestions on electrical problem
- Help I think I screwed up?
- Engine similarities VTR vs. RC51
- Manual CCT install thread
- MORE jetting problems
- BattleAxe BT012?? Toss or keep?
- Footpeg Feelers
- No Start?
- How to Remove a 10 yr. old Nut?
- Triumph Tiger '07
- valve spring compressor?
- Strange rattling
- Engine stutter on deceleration
- Adding 2nd cooling fan
- will 06 cbr600rr wheels fit on a superhawk?
- regulator rectifier temp
- eed help bike sputters bad
- Now I've seen it all......lololol
- Looking for a tire tool..
- Need advice about charging system
- 600rr M/C. Spongy Lever?
- front cyl vacuum fitting for sync
- Tankslapper, nearly got ejected !!
- already swapped/upgraded front ends?
- other swing arms
- Good working setup for carbs
- 954 wheel equivalent???
- Rear brake mounting?
- Another CCT thread
- Manual CCT install - 2 problems
- Yes I know, but another carb question
- EVX~~~orEIX?.......that is the Question....
- Paint
- funky decel...
- Vibe/chatter through clutch.....oil thinning out?
- What other years models use same fork tubes?
- Thread size for flywheel??
- cylinderhead swap back to front???
- help
- So I just GOTTA ask - why TWO carbs?
- Wilbers owners please.........
- Another Carb Thread....
- Noise after trackday crash and pipe swap
- R/R replacement
- Chain help
- Compatability
- How accurate is the stock tach?
- full of hot air
- Headligth switch... A question?
- Sick Hawk, timing?
- electrical problem?
- Troubles
- Wiper blades.
- Help! Electrical burning!!
- fork swap question
- torque specs
- Cylinder quit, installed new plugs, still nothing...
- Choke Questions
- vtr calipers on 929 forks
- Carb shim mod.
- Filter, sub A/CLNR --- HELP
- Clutch dragging after fluid flush
- factory jetkit - going back to stock
- sprocket size
- Manual CCT adjustment Question
- Suspension set up for a 205 lb. rider?
- Prospecting SSSA conversion - some Qs
- Stock Header size?
- Plastic repair
- Charging Help
- R1 Rectifier rewiring
- removing right footpeg mount casting
- Rear axle nut - how many mm's ?
- 99 been losing oil ...
- Converted factory CCTs to manual
- Best 80 dollar tool and 15 minutes spent....
- ape ccts?
- draining coolant
- sh problems
- Tank Bag and Rough Throttle Response
- Clutch Problem Slippage only high speed
- Try to figure this one out.
- Electric fuel pump
- Break in procedure for motorcycles, etc...etc...
- High Compression
- superhawk sputter???
- having big problems with my SH
- These settings sound good? (Carb assistance)
- Strange engine noise
- Help! Hawk wont start
- 4 degree advancer works well on '98
- Dirt in motor
- Hot starter
- Flywheel removal
- Just installed 4 degree advancer...
- Will a RC51 alt cover.....
- Bad noise/vibration..clutch?
- 2000 super hawk not fireing on front cylinder
- stops at light
- R1 rectifier
- HELP, bike stalling
- revs
- front turn signal upgrade?
- mirror replacements
- OEM swingarm wall thickness
- Transmission Problem
- front tire size question
- Fuel Economy
- Rattling sound
- 929RR Front End Swap Question.
- Battery discharging (current leak)
- Tire size question..>
- Way rich jetting and still 3-4k stumble?
- Need help with Head/Bearing Adjustment
- Uh-ohh... coolant leaking out of mechanical seal inspection hole. What now?
- Tuning question... Really strange?
- Carb cleaning???
- I am a moron
- Choke broken- reason why bike won't start?
- WHAT A DIFFERENCE the right spring makes!!!!
- Shinko Tires?
- An Inexpensive DIY Carb. Sync. Tool
- CCT interchange - need answer asap!!!
- Throttle position sensor question
- The RR
- 929RR Rims
- more help needed
- Rear sprocket hub dampners
- Replacing cylinder head - any suggestions?
- "Clack" at idle
- RATTLE OR POSSIBLE PING NOISE?
- need help starting bike
- Noise/feeling ? Not CCT! :)
- Confused on the front caliper swap issue....???
- New bike occasionally misses making a strange noise
- I need help with a nasty noise
- Ohlins steering damper
- Timing Question...?
- Need some Advice - Gastank removal
- A different sort of CCT thead
- Had my first "failure"
- Exhaust question ...
- HOT!
- sweet!! i found a little green puddle
- Drilling a hole in the carb slide?!
- Throttle Response
- Rebuild or replace head?
- CCt should be easy, right?
- Whats wrong with my clutch?
- Oil consumption
- Fitting RC51 Clocks
- WTF???? Died in flight friday night
- SH has sprung a leak - oil pan or clutch related? help!
- vtr 1000 to honda interceptor
- Need rearsets for a '98 Hawk
- Ive asked before with no real help but lets try again PLEASE... Bike stumbles at half
- Ign timing wheel mod???
- backfiring and less than optimal power
- carb idling question
- Shaking Bolts Loose
- Dang pilot screw has me pulling out my hair!
- Need to drop coolant level
- Fuel problem/vent?
- A few issues/concerns.
- high rpm problem
- Today's ride and APE leak
- Carb help!! PLEASE!
- Electrical dead
- ape manual ccts-how often/mileage to re adjust?
- HELP, dies when put in gear
- Rattle when you rev the engine
- Diesel Superhawk
- Any reason not to mod valve shims by hand?
- Brake Upgrade!
- Stator Problem? Need Help
- hey guys new to the forum. but a tech for these bikes.
- telltail hole
- rejetting for trackday
- Shimming valves tomorrow...any tips?
- Going to two long intake stacks....new jetting?
- Sprocket combo
- Water temperature
- Improving Stock Suspension (Front)
- Mechanic Needed: real trouble!!
- Bafflectomy hard ??
- busted cam chain
- Jetting on a 996 Super Hawk with Jardine Slip On's
- Sliders Available
- I got problems!
- using meter to test rg/rect?
- 2000 Hawk w/22k jumps out of 2nd @ 7k
- Stock Baffle Mod ??
- Electrical/wont start!!
- clunky tranny
- Exhaust Question
- question for another 1999 owner
- Thermostat housing leak
- Scorpion Exhaust
- cam chain adjuster update .
- Gear Indicators
- stock fork spring rate?
- APE CCT Leaking Oil
- Rear shock from what other bikes will fit VTR????
- Recommended Tire Pressure
- Newbie Needs Help With Vtr Question
- Stock cam chain tensioner.
- stiff clutch
- My 1st Hawk questions
- Draining Coolant
- Erratic ft. stopping power
- Filter Cross-reference
- Charging system diagnosis help
- tach died, please help
- Why do I have this?