View Full Version : Technical Discussion
- Muffler Re-pack
- 2.0 radiator cap
- Super hawk won't start when hot,please help
- Crankcase cap seized?
- ICM Yellow liquid Leak
- Down On Power - CCT Issue?
- Clicking sound
- Idle screw plug?
- new to me 2003 superhawk 1000cc motorcycle
- New Owner Discovering Super Hawk
- Cam Chain Tensioners
- Replaced top radiator hose
- Battery drain ,possibly electrical, none due to fact of rr,or stator
- Stalls all the time
- Clutch fluid missing
- greetings from Sweden please, i need some help
- Random fart valve??
- Good place to tap harness 12vdc?
- Need carb help in the Seattle-Tacoma area
- Popping on Deceleration and rough at light/neutral throttle
- Front Cylinder Intermittently Firing
- surging and other issues.
- Does a 1997 front brake set fit a 2005 model?
- Brake Caliper Piston Configuration
- Change your thermostat........
- help with popping at throttle and on decel
- Depleting coolant and overheating
- Turning 25,000 miles, should I adjust valves
- ARGH! The Grease!
- Fuel tank lower plus airbox top I need advice asap.
- Replacing valve cover gaskets...Which sealant?
- Side stand not killing engine
- composites. questions and tips. not for kids.
- What??
- Replacing right crankcase cover
- 1998 Superhawk - Fueling to Vacuum Issues
- Superhawk won't stay running
- carb over flowing issue
- Li-ion Battery
- Instant warm hands
- 55 vs 50 series rear tire?
- CCT upgrade, cam sprocket position???
- Missing
- Can't remove carbs
- Stock master cbr brakes?
- Finding a short
- Stupid header donut
- Double banjo bolt with bleeder
- Ejected the rear plug?!?!
- Who has a cbr600rr front end?
- I Fluked up! Dunno maybe over tight...
- This is Niot a VTR?
- Ok who has the 1000rr rims front and rear on stock ss.
- SpeedoHealer
- horrible noise. Head rebuilt.
- Used Oil Analysis
- Rotating the cams.
- Anyone aluminum monocoque tail? Just a discussion about it.
- Got a light problem
- Anyone run ALuminum brakes
- Starting trouble - engine seems stuck
- Having issues with my 2003 vtr1000f
- chain length
- Backfire shaking
- How to Properly Read Plugs
- Slipper clutch?
- Bike bogs down approaching top speed
- Runs great cold then poor idle when hot?
- Sputter.....
- Bike height
- Givi brake lights
- A different neutral light problem
- 1998 VTR low miles off idle sluggishness
- Lack of beer. Rim machining idea.
- Weird starting problem
- New R/R gone wrong
- New starter
- Speedometer issues
- Cct install problem
- What is factory and what isnt?
- Fuel tank swap question
- New bike, a few questions
- CBR600F4i Showa shock remote reservoir hose MOD
- tether switch options
- Air/fuel ratio
- Coerce rearsets
- ok, pistons hit valves...repair $
- Some cooling tips
- No fire rear cylinder, yes checked pvlir
- Deglazing brake discs
- low rpm...no power
- 1998 VTR intermittent cut out-light dimming
- 1 or 2 muffs on race bikes?
- timing?
- remove/reinstall top triple clamp. easy?
- Hand guard mount
- Choke stuck open after carb installation?
- APE CCT's Pro series
- Coolant leak near thermostat?
- Clutch cover oil sight glass removal
- Bike bogging at certain rmp in each gear.
- never carb sync'd b4
- Rough Running under hard acceleration
- Starter or relay?
- Superhawk Help
- Bike not running properly
- Clutch Master Cylinder
- hard cold starts everytime with a backfire
- Cam Chain Tensioners
- slappy wrap sound 7.5-8k rpm
- Coolant bottle swap
- Air Box question!
- Gas everywhere
- Carb Tuning Information
- Need some advice/help
- Help!!!
- fuel problems need help
- what is the "S" amber dash llight for ?
- 2005 Front Brake Master Cylinder Sub-Assembly Mounts on Older VTR?
- Rad cap replacement
- Modify Master Cylinder for brake lines?
- RTH - Factory Pro Shift Star kit install help req'd
- Front brake issues
- Stick Coil Mod
- Rough Idle - Video of problem
- Brake Master Part ID
- clutch basket play??? correct or not??
- cam issues? ALL HELP NEEDED!!!
- How to change or clean the fuel filter?
- Clutch not disengaging
- new here
- VTR running poorly and dies. Aluminum flecks on plugs
- I need help
- Why do I need to service my brakes and Why don’t they work well after bleeding
- Carb bowls
- Help with rear brake noise when moving backwards
- New Member Welcome + Tyre question
- More handguards
- Double banjo source
- Carb problem advice
- Electrical problems
- Cluster LED color?
- Coil is good only running on 1 cyclinder
- 2000 Firestorm not sparking on front cylinder
- Stator Resistance at 2.5 Ohms??? Toasted??
- Front Brake Calipers & Disc
- Hayabusa 6 piston on stock Sh forks
- Removing the carbs with the air box housing attached?
- Missing vacum line
- What shock to use with Sp2 arm conversion
- Hawk Died on Freeway
- Plug resistance.
- Removing the fake guage face bolt
- Gouge in Fork Internals
- Check CCT?
- Special Tools - Steering bearings
- engine tick
- starts fine runs rough after warming up
- Fault?
- Broken frame tabs, fairing stay repair?
- Mucky rotors?
- petrol cap stuck?
- Master Cylinder sight glass replacement
- Carb sync & rejet....approx how many shop hours?
- Rebuild time
- Is 40,000 miles to high?
- race petrol cap why?
- FIXED: new superhawk owner, running issue constant throttle
- Need help! An internal portion of the fork leg got sandblasted
- Shock linkage lubrication, ehaust heat
- 98' SH...won't start?
- Should I consider this...!!?
- 04 aprilia tuono r Factory
- factory pro shift kit install instructions.
- Engine noise due to anti rattle gear adjustment
- Factory pro shift kit review.
- How many bottles of fork oil to buy?
- Pixie dust in my coolant???
- 98 VTR1000 Wheel assembly Collar HELP
- Over flow & potential fuel leak 98 VTR
- What size is the clutch hub nut?
- metal in the oil
- DMr Cartridge Kit
- Timing off on rear cylinder?
- Won't Start :(
- Airbox volume requirements
- Driving lights
- When Synching Carbs
- Airbox questions: Oil and Foam
- Is the chain supposed to drag on the swingarm?
- SERVICE MANUAL UPDATE!!!!!!!
- Holy Engine Brake Hawkman!
- Coolant in OIL!!!!
- Dealing with milkshake.
- Brakes, check my beer math
- Desulfating battery charger
- Lithium Battery Help
- Pulling off old exhaust
- Oil pan bolt torque value
- Engine acting up at low speeds.
- Newer super hawk owner. Need help!!!
- GPI radiator installs?
- Turning crankshaft rotation bolt while bike is in gear
- Beatin' a very Dead Horse
- Cam Gear Timing Marks 180 Degrees Off??
- Need Engineer opinion - Bolt Swap
- Why, Why, Why? Hot fuel.
- UN
- Members, I am in need of some information
- Carb TMS Recommendations
- Airbox threads stripped
- Revs hanging at 2k when blipping the throttle
- VTR Down Under
- Hi! New member, new SH.... scary noises
- alternative to progressive springs?
- cam chain tensioner help ?
- Help! Nighthawk won't run after carb rebuild.
- 1000rr speedo question
- Throttle Stop Screw-Big Difference with Adj.
- Electrical rant
- Identify USD forks?
- Mosfet wiring!
- ECU differences?
- Anyone know what type of bike this is
- Well i messed something up....
- Twinmax carb sync tool
- Gauge choice
- Fuel in cylinders
- Tach accuracy
- how can I reset cam timing with all cams out
- Need help . Electrical
- Fuel gauge mods
- '04 with no spark.
- Shifter Linkage Replacement
- Crank balancing specs anyone (urgent!!!)
- Tach inop
- Rear carb wont take fuel
- Carb settings with high comp. pistons & cams
- starter won't turn bike over
- Help identify this hose...
- Engine sputters inconsistently under 4000rpm
- Bad battery, short? ?
- Antifreeze shooting all over floor
- Red Hot Exhaust
- Tach not working and cam timing question
- Steering Head Bearing nuts driving me NUTS!
- Clutch Help
- No Spark after running out of gas
- Questions for Tweety
- Oil Leak somewhere