I just replaced the Clutch Master Cylinder assembly and now I have no pressure in the clutch handle and it stalls when i try to put it in gear. When I hold the clutch while the bike is in 1st I cant roll it.

Please help

 

Have you bled it?

 

++++1

 

couldn't agree more and even if you did i would run fluid through the system again just to make sure.

Also on a side note you want to make sure that you open and close the bleed nipple properly when your putting fluid through the system.

 

Try bleeding it twice after you think it's good Clutch bleeding can be finicky because you don't get the lever feel like you do with brakes. Watch the fluid coming out of the hose attached to the bleeder. Only let a somewhat small amount to come out each time and be very cautious to not let that small **** cup get empty. Keep at it and you'll get it.