Does anyone know how to tell which emulsion tube goes where? Also, I heard the needles are different, too. If that's true, anyone know how to tell which one goes where on those?

 

 

You should probably read this:

https://www.superhawkforum.com/forum...-set-up-24769/

 

Thanks, I saw the carb set up post right after I posted this.

 

I am aby-normal on this topic as i run the same emulsion tube in both front and rear with great success around surging. There was a topic on this years ago on another forum where some guys tested changing this. I would have to check my notes, but a seem to recall i have the rear style emulsion tube in front and rear carbs.

 

Running a rear emulsion tube in the front is the Factory Pro way of dealing with the issue. Personally I prefer, and have seen, better results by using the HRC method of plugging a lift hole in the front slide.

Though that is just me.