Moriwaki full race exhaust: Help with this dang thing!
#3
Re: Moriwaki full race exhaust: Help with this dang thing!
I have one. Titanium headers and carbon mufflers. I have only just purchased it second hand and it is sitting in a box in my garage.
What do you want to know?
What do you want to know?
#4
Re: Moriwaki full race exhaust: Help with this dang thing!
The mid-pipe on the right side is a bit longer than on the left; I've left the nuts a little loose on the headers so that I can move the joints around and see what works best, but still too long. Do you happen to have any litterature you could scan and send via email Shayne?
#5
Re: Moriwaki full race exhaust: Help with this dang thing!
Sorry, no instructions.
I have gone and had a look at mine, and I cannot see any room for adjustment. You mention a "mid pipe" which I assume to be the pipe between the muffler and the collector. On my system these pipes are integral to the muffler, and are of equal length on each side, although of a different shape of course.
Is it possible that the muffler mount is at fault?
Do the mufflers end at the same position at the rear of the bike?
No other ideas I am afraid. If all the joints are fitted together properly, then that only leaves some production error to be the fault.
I have gone and had a look at mine, and I cannot see any room for adjustment. You mention a "mid pipe" which I assume to be the pipe between the muffler and the collector. On my system these pipes are integral to the muffler, and are of equal length on each side, although of a different shape of course.
Is it possible that the muffler mount is at fault?
Do the mufflers end at the same position at the rear of the bike?
No other ideas I am afraid. If all the joints are fitted together properly, then that only leaves some production error to be the fault.
Thread
Thread Starter
Forum
Replies
Last Post
FL02SupaHawk996
Classifieds
39
02-09-2009 07:42 AM