hesitation after installing dyno jet kit and k&n
Guest
Posts: n/a
Re: hesitation after installing dyno jet kit and k&n
bike runs great no problems it cant get no better has so much acceleration and cruising speeds are steady!awesome v twin power and rumble just got my skinz put on and the exhaust sounds very good (wiley co)thanks for all the input and if anyone knows i got a extra superhawk for sale with no front plastics and 6200 miles on it it runs great it is a 2000 and i bought an 2001 !i have the sharskinz front for a extra 700.00 dollarsi want to get 4000 out of it but who knows?
Member
Squid
Joined: Mar 2005
Posts: 43
From: Portland ORegon
Re: hesitation after installing dyno jet kit and k&n
I had a separate post about the same problem and thought I'd reply to this one since there is so much more info.
I can't thank the forum enough, it really made the difference in my work. I gathered all the experience people shared and took care of my problem in a night after work. I have Erion pipes and a Dynojet kit installed by the previous owner. I had a misfire at low rpm and other symtoms similar to other riders. I raised the needles one clip, did the TPS adjustment (it was over 800 ohms), cleaned and greased the carbs as recommended in the 'Knowledge Base' section. I even had time to adjust the shifter and give the rear-fender-mullet a bit of a trim. Slapped it all back together and tore down the street on one wheel.
The info shared here is huge. Thanks again.
I can't thank the forum enough, it really made the difference in my work. I gathered all the experience people shared and took care of my problem in a night after work. I have Erion pipes and a Dynojet kit installed by the previous owner. I had a misfire at low rpm and other symtoms similar to other riders. I raised the needles one clip, did the TPS adjustment (it was over 800 ohms), cleaned and greased the carbs as recommended in the 'Knowledge Base' section. I even had time to adjust the shifter and give the rear-fender-mullet a bit of a trim. Slapped it all back together and tore down the street on one wheel.
The info shared here is huge. Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
snowman666
Technical Discussion
8
Dec 7, 2008 08:31 PM
V-Raptor
Technical Discussion
16
Aug 8, 2008 02:37 AM
