**Black Plate Bolt Lights - Cheap**
05-12-2010, 05:32 PM
#1
Senior Member
Back Marker
Thread Starter
Join Date: May 2009
Posts: 175
**Black Plate Bolt Lights - Cheap**
I bought some lights for my plate, these: http://www.d2moto.com/ProductDetails...e=LPL001-Black
However, I bought an LED taillight also that has a built in plate light so have no use for these. I'll get rid of them for $10 plus shipping.
However, I bought an LED taillight also that has a built in plate light so have no use for these. I'll get rid of them for $10 plus shipping.
05-12-2010, 06:48 PM
#2
pragmatic anarchist
Superstock
Join Date: Mar 2008
Location: Philadelphia, PA
Posts: 380
Actually I read a couple threads on the questionable visibility of the integrated taillight and I stuck a set of those in the passenger pegs, just bright enough to give you that extra bit you might need. I have a rack and put them a little too far up where the bracket is widest, but without a rack you can go pretty high.
05-15-2010, 05:58 AM
#4
pragmatic anarchist
Superstock
Join Date: Mar 2008
Location: Philadelphia, PA
Posts: 380
Yeah, gets the turn signal lights a little further apart so your intentions are clear.I just tapped into the signal wires with mine. Integrated tail has separate wires for signal hot and grounds through the brake, taillight, license light connector. I think I grounded to the original signal grounds on the harness. I'll check later today and post if different.
05-22-2010, 09:38 AM
#8
Senior Member
Back Marker
Join Date: Jan 2009
Location: Hemet ,CA.
Posts: 167
[quote=swaptrex;265617]I bought some lights for my plate, these: http://www.d2moto.com/ProductDetails...e=LPL001-Black
I got a set of these too. Not as bright as I had hoped, but they work.
I got a set of these too. Not as bright as I had hoped, but they work.
05-22-2010, 10:07 AM
#9
Senior Member
Superstock
Join Date: Sep 2009
Location: Woodland Hills, CA
Posts: 421
[quote=dickard37;267027]
It looks like adjusting the angle downward might help? (Judging from all the light above the plate.) A pair of washers to raise them off the plate slightly might improve things too.
I think I might have to look into these if I end up trimming my fender.
I bought some lights for my plate, these: http://www.d2moto.com/ProductDetails...e=LPL001-Black
I got a set of these too. Not as bright as I had hoped, but they work.
I got a set of these too. Not as bright as I had hoped, but they work.
I think I might have to look into these if I end up trimming my fender.
Thread
Thread Starter
Forum
Replies
Last Post
rafbo
Modifications - Cosmetic
113
01-03-2019 02:38 PM
