Wiring question - 98 Hawk
Thread Starter
Senior Member
Superstock
Joined: Oct 2009
Posts: 250
From: NJ/NYC
Wiring question - 98 Hawk
Okay, so I bought the flushmounts and am ordering the leds for the flushmount III's, but the wiring isn't long enough. I am not electrically inclined too much so I ask the skilled here.
16 - 18 - 20 guage wire? and where can I get the snap clips that are already on them so I can just add another foot of wire to the connection?
16 - 18 - 20 guage wire? and where can I get the snap clips that are already on them so I can just add another foot of wire to the connection?
Senior Member
MotoGP
Joined: Mar 2007
Posts: 3,132
From: Phoenix, AZ
Where is the wiring not long enough? I had no such issues with Lockhart Phillips FlushMount IIIs.
edit: There is about 5-6" on the lights, that's plenty.. The wiring harness from the bike is long enough to reach down to them, you might have to free it up somewhat is all.
edit: There is about 5-6" on the lights, that's plenty.. The wiring harness from the bike is long enough to reach down to them, you might have to free it up somewhat is all.
Last edited by lazn; Sep 21, 2010 at 04:23 PM.
Banned
MotoGP
Joined: Aug 2007
Posts: 5,942
From: Lake View Terrace, CA
I have never had any issues with the turn signal leads being too short. Are you putting them in the stock location?
Thread Starter
Senior Member
Superstock
Joined: Oct 2009
Posts: 250
From: NJ/NYC
I am trying to rig them to fit into the stock locations, I will try and pull on the existing wire and then figure out which is turn signal and which is solid signal.
Thread
Thread Starter
Forum
Replies
Last Post
DavidEW
Modifications - Cosmetic
22
Aug 7, 2014 07:14 PM
