small hole in oil pan
#1
small hole in oil pan
long story short i was run off the road and downed my bike. the only major damage was a hole in my oil pan about a half an inch long and about a quarter inch wide. need to see if there is an inexpensive fix untill i can afford a new oil pan. JB weld, ect. any thoughts?
#2
#3
thanks man. i found that one, but mines a 98 and more expensive. dont have the 80+ dollars for it yet. i was hoping for something cheaper and temporary
Last edited by dr_gonzo; 06-11-2012 at 02:38 PM.
#4
All years should fit. Any temporary fix could end up very costly and painful if the bodge fails and drops oil...
At minimum take the pan off and find a welder experienced with welding ali
Welding - Beginner Guide to Aluminum
At minimum take the pan off and find a welder experienced with welding ali
Welding - Beginner Guide to Aluminum
Thread
Thread Starter
Forum
Replies
Last Post
Bluesuperhawk83
Technical Discussion
6
07-31-2012 04:15 PM