Manual CCT initial adjustment
Thread Starter
Senior Member
Back Marker
Joined: Sep 2004
Posts: 206
From: Salt Lake City, UT
Manual CCT initial adjustment
I know there was a post about this but I can't seem to locate it. As I recall you finger tighten them until tight then back it off a certain amount. I can't remember what that amount was. . .Anyone?
Senior Member
SuperSport
Joined: Dec 2004
Posts: 764
From: Nananimo, B.C.
Re: Manual CCT initial adjustment
No, its more complicated than that.
Make sure to measure 1/4" TOTAL SLACK between the lobes NOT deflection
Here it is:
https://www.superhawkforum.com/viewtopic.php?t=588
Make sure to measure 1/4" TOTAL SLACK between the lobes NOT deflection
Here it is:
https://www.superhawkforum.com/viewtopic.php?t=588
Thread
Thread Starter
Forum
Replies
Last Post
