carb vacuum piston
#2
They are not cheap and are you sure they are worn and all that?
If you do need to replace them this is about the best price you will find:
Honda, ATV Parts, Scooter Parts, Motorcycle Parts,CRF,CR,MX Parts, Goldwing parts
Even so they are $75 each.....
If you do need to replace them this is about the best price you will find:
Honda, ATV Parts, Scooter Parts, Motorcycle Parts,CRF,CR,MX Parts, Goldwing parts
Even so they are $75 each.....
#3
Jack of all Master of non
Superstock
Thread Starter
Join Date: May 2011
Location: Jacksonville,fl
Posts: 297
i am pretty sure they are worn, they have grooves worn in the wings were it slides. i think they are the issue but i just cleaned them and i still have a rattle during acceleration. i did the pair blank off and seams to work pretty good and richened up the main jet one groove. the rattle does not sound catastrophic but it annoys the hell out of me.
i also tried to sync the carbs up but the gauges i have were very jumpy and could not get a solid number. i am at a loss, i just might sell it, i dont know what to do. never fails i always get something that has problems.
i also tried to sync the carbs up but the gauges i have were very jumpy and could not get a solid number. i am at a loss, i just might sell it, i dont know what to do. never fails i always get something that has problems.
#5
Remember stock is BAD!
SuperSport
SuperSport
Join Date: Jun 2004
Location: Jacksonville FL
Posts: 760
Give me a call tomorrow. I will come over and help ya. I'll bring over my vacuum gauges and we will get her synced. Also I found the fitting that goes on the front cyl head.
Also when we met up you mentioned swapping slip ons, you still interested?
Also when we met up you mentioned swapping slip ons, you still interested?
Thread
Thread Starter
Forum
Replies
Last Post
98VTRrider
Technical Discussion
5
12-20-2011 12:33 PM