Does anyone make a carbon chin lower?
#1
Does anyone make a carbon chin lower?
I did a little searching and haven't found anything relating to if anyone makes a carbon chin lower like our stock one. Does anyone know if a company does make one? Sorry if I've overlooked it, but if so, someone please post up!
If nobody makes one I may see about wrapping mine in CF then vacuum forming it over the stocker (extra stock one I'll have to buy for mold process). Also wouldn't mind making a custom one from fiberglass slightly different than the stock geometry for a subtle change.
Something like this...
Anywho, I would like to know if a company makes one and if so, please post a link. Thanks!
If nobody makes one I may see about wrapping mine in CF then vacuum forming it over the stocker (extra stock one I'll have to buy for mold process). Also wouldn't mind making a custom one from fiberglass slightly different than the stock geometry for a subtle change.
Something like this...
Anywho, I would like to know if a company makes one and if so, please post a link. Thanks!
#4
#5
That's the most beat-up part of the bike. If you were to find/make one then I HIGHLY recommend some kind of clear 3M film over the front and bottom of it.
If Autoteach were to make one I'd most likely buy it (hint, hint).
If Autoteach were to make one I'd most likely buy it (hint, hint).
Thread
Thread Starter
Forum
Replies
Last Post
captainchaos
Classifieds
7
01-09-2013 02:04 PM