Perplexing Problem - Stalling and Running on 1 Cylinder
05-06-2007, 03:09 PM
#1
Escape Reality
SuperSport
Thread Starter
Join Date: Jun 2006
Location: KANATA, KANADA
Posts: 612
Perplexing Problem - Stalling and Running on 1 Cylinder
Hey guys,
I recently changed the exhaust on my hawk and did a cleaning of the air box after my latest CCT install. Ever since then, I have a major issue with it. The hawk starts fine but once it is warmed up at a little below the first mark on the heat gauge, the engine would stumble and eventually dies. After shutdown, I start again, it is fine then dies again. After several tries as it gets warmer, it would not rev at all. I believe everything is correct and I do not think it is the exhaust since it only happens when warm. I cannot seem to figure this out.
I have taken the damn thing apart several times over the weekend and I am about to give up and kick it over.....Please help me out..
I recently changed the exhaust on my hawk and did a cleaning of the air box after my latest CCT install. Ever since then, I have a major issue with it. The hawk starts fine but once it is warmed up at a little below the first mark on the heat gauge, the engine would stumble and eventually dies. After shutdown, I start again, it is fine then dies again. After several tries as it gets warmer, it would not rev at all. I believe everything is correct and I do not think it is the exhaust since it only happens when warm. I cannot seem to figure this out.
I have taken the damn thing apart several times over the weekend and I am about to give up and kick it over.....Please help me out..
Thread
Thread Starter
Forum
Replies
Last Post
