I finally gonna see!!
#1
I finally gonna see!!
My Bi-Xenon kit is coming in from TRS today and I cant be more excited. The PO put some ridiculous light setup in there without the proper reflective backing and it posed 2 problems. It didnt have a low beam, and it spewed light EVERYWHERE.... IT would literally light up the trees over my head. I finally got sick of people flashing there lights at me as I blinded them, so I just went ahead and bought it.
So.... my question is, for those of you who have done this retrofit, DO I need to seperate the plastic lens from the headlight housing to install the shroud? I got their sportbike stage III kit. I also plan on doing a custom black backing plate to insert inside there at one point so im gonna have to seperate it anyway, but I was just curious if I had to do it now. My buddy has a flo-jet table and if I have to take it apart to install, ill just start designing that backing plate for him to cut out now, and just do it all together.
Thanks guys... now im gonna go ride until UPS gets here ITs one of those rare last few days of semi-warm sunshine before I start my winter projects.
So.... my question is, for those of you who have done this retrofit, DO I need to seperate the plastic lens from the headlight housing to install the shroud? I got their sportbike stage III kit. I also plan on doing a custom black backing plate to insert inside there at one point so im gonna have to seperate it anyway, but I was just curious if I had to do it now. My buddy has a flo-jet table and if I have to take it apart to install, ill just start designing that backing plate for him to cut out now, and just do it all together.
Thanks guys... now im gonna go ride until UPS gets here ITs one of those rare last few days of semi-warm sunshine before I start my winter projects.
Thread
Thread Starter
Forum
Replies
Last Post
EngineNoO9
General Discussion
20
01-03-2007 09:13 PM
superhawk22
General Discussion
4
06-20-2006 10:38 PM