high mounts and passenger pegs??? pics/help needed
#1
high mounts and passenger pegs??? pics/help needed
bought a Hawk with remus alum. high mounts.....the passenger pegs were removed, i'd like to put them back on. does anyone have pics of high mounts with pass pegs on? i can't seem to figure out how to make this work. thanks so much in advance
andy
andy9743@aol.com
andy
andy9743@aol.com
#2
Without seeing a pic of yours, I don't know if this will work but most simply use longer bolts and spacers to set the peg mounts out past the cans. You can do this yourself by getting some bolts and box aluminum tubing from a home supply store.
#3
here is a pic of the pipes:
http://s198.photobucket.com/albums/a...t=P6070001.jpg
still thinking that square tubing and longer bolts will work?
thanks
andy
http://s198.photobucket.com/albums/a...t=P6070001.jpg
still thinking that square tubing and longer bolts will work?
thanks
andy
#4
If money is no object you can buy them from any of the companies like Jardine, Leovince, etc that make them. Otherwise, Home depot by me sells hollow aluminum (and also steel) round tubing. All you need are longer bolts and cut a small length (should be @ 2 to 2 1/2") for each bolt to space the pegs out far enough to clear the cans. Hold your pass peg up in place and measure the space. The spacers go between the hangers and the pegs. A bolt supply house will probably your best bet to match up the right bolts. Hope this helps!
#6
Cool hope you find what you need The spacers you get won't be EXACTLY the same as the ones in the pic (mine are from Leovinci) but you can find some stuff to serve the purpose fine. The hole in the center may be a little bigger but once they're tight (and maybe a couple washers if necessary) they'll work fine.
Thread
Thread Starter
Forum
Replies
Last Post