Help removing plastic clips holding the tail section
#1
Help removing plastic clips holding the tail section
You know those 2 plastic trip clips holding the tail section/rear cowl on? Is there any way to remove and reuse them? My inclination is to yank them off with a pair of side-cuts!
Any help would be much appreciated.
Any help would be much appreciated.
#2
If they have a phillips head in the center carefully turn it out until you can grab the head and pull it out.
If it is just the button fastener then push in the center and you can pull it out. Pull the pin all the way out the reuse the clip
If it is just the button fastener then push in the center and you can pull it out. Pull the pin all the way out the reuse the clip
#3
If its what I am thinking, they are kind of like plastic wall anchors. There is a grommet and a kind of peg that goes through it to expand it. Carefully pull the center piece out, I use a thin flathead screwdriver then needlenose. Once displaced, it releases the expanded plastic & therefore the bond.
Not sure if that makes any sense but its a honda thing.
Not sure if that makes any sense but its a honda thing.
Thread
Thread Starter
Forum
Replies
Last Post