Bar End Question
Thread Starter
Senior Member
Back Marker
Joined: Nov 2008
Posts: 186
From: Calgary, Alberta, Canada
Bar End Question
I am looking for a decent set of chrome bar ends that are heavy and on the longer side for protection and I don't trust the cheap ebay ones. Any suggestions?
Senior Member
Superstock
Joined: Jan 2007
Posts: 276
From: Ranson, WV
Senior Member
Superstock
Joined: May 2008
Posts: 347
From: S.Dak USA
www.bikebandit.com/bar-ends/c/a658105?mg=7754&t=1
Check out the Pingel's. If you want extra weight,pull the stock damper assembly from the clip-on,add some lead shot,replace dampers,fit bar-ends.
Check out the Pingel's. If you want extra weight,pull the stock damper assembly from the clip-on,add some lead shot,replace dampers,fit bar-ends.
Last edited by steve.g; Jan 2, 2009 at 04:17 PM.
Senior Member
MotoGP
Joined: Sep 2006
Posts: 4,138
From: Austin, Tx
I have 11.75 oz stainless steel ends that are about twice as long as the stockers. They were purchased to address the vibration or ringing in the bars. They worked but not enough. I eventually bought Helibars, installed the stock weights and the stainless bar ends and things are pretty good. I cannot remember where I got them. I think it was ebay but I haven't seen them there for a long time. Good luck!
Thread
Thread Starter
Forum
Replies
Last Post
