97-00 Parts book
Thread Starter
Jack of all Master of non
Superstock
Joined: May 2011
Posts: 297
From: Jacksonville,fl
i need the spacers that go with the original jets for a SH carbs... mine has a dyno Jet and who ever installed it did not put them in when they re jetted the carbs(dumb asses) plus i need some other random parts...
Senior Member
SuperSport
SuperSport
Joined: Jan 2011
Posts: 521
From: Tampa Florida
Xtreme Powersports' 2000 Honda Street Bike VTR1000F SUPER HAWK Parts List
you can order from them too. Most local honda shops have this kind of service. these guys are a bicycle ride from my house here in tampa so I never have to pay shipping.
you can order from them too. Most local honda shops have this kind of service. these guys are a bicycle ride from my house here in tampa so I never have to pay shipping.
Thread Starter
Jack of all Master of non
Superstock
Joined: May 2011
Posts: 297
From: Jacksonville,fl
the ones that go between the c-clip and the slider housing. the instructions say to use the original spacer on old needle jet for the new dyno jet one but the dubm a$$ didnt put it on.
Banned
MotoGP
Joined: Aug 2007
Posts: 5,942
From: Lake View Terrace, CA
You might want to lay of the happy juice as you are the one asking about spacing the jets.....
or don't you remember post #3 in this thread???
or don't you remember post #3 in this thread???
my e-penis is huge!!
Superstock
Superstock
Joined: Sep 2005
Posts: 257
From: belvidere nj
FYI,
Needle jet spacers are about 20 thousandths thick. It is the equivilent of 1/2 of a e clip setting. Make sure you dont put too thick a washer in there. Also mic them to be sure they are all the same thickness, or you will throw off the jetting.
Needle jet spacers are about 20 thousandths thick. It is the equivilent of 1/2 of a e clip setting. Make sure you dont put too thick a washer in there. Also mic them to be sure they are all the same thickness, or you will throw off the jetting.
Thread
Thread Starter
Forum
Replies
Last Post
smack doogle
Buyer/Seller Feedback
1
Jun 8, 2008 02:48 PM
