For sale $300 +Shipping
Rim with sprocket hub and just some sprocket and barke rotor and Caliper, Shims, Axles, Brake Caliper Bleader points Up and rotor, Shock Linkage\
All you will need is to Clean it up / finsh to your tast bearing felt good but I would repace all bearings and seals.
Would have to ship in at least two boxes
The pivit point was welded by a profesional welder He pre heated it
Not all of the photo's are of my bike I never installed it. They are from a different fourm member

Do not know why photos are so big






shows compleate setup not including Motor. I did not change the bearings as I did not finish it. two many other bikes to do.

Shock LInkage

Stainless Steal

 

Damn that's friggin' awesome and a smoking deal too. I was into my SP2 setup for over a grand years back after a forum member who originally built it for me screwed me over twice and then Thunder Cycle from the Discovery Channel screwed me also (amazing how incompetent so many "experts" are). I had mine built to keep the wheelbase stock, which cut things a little too close (if I could do it over I'd have added a smidge of length for a little more clearance). Mirror polished mine by hand too myself after someone wanted $500 or $600 for that. Even ending up getting screwed out of most of my money when I sold it. Just bad juju all the way around don't miss that damn thing. Did this extend the wheelbase and if so by how much? Also assuming the ride height is the same? Damn hard for me not to pull the trigger on that but I sold ALL that stuff off my bike and am putting everything back to stock so I can eventually sell it. Going to make someone happy that's for sure.

 

Knock it off, chaos, I'm doing my damndest to not buy this.

 

But just think how nice it will be. I have the chain gard not sure but i might and mean might have the fender for it.