Rear turn signals
#1
Rear turn signals
Bought these because they were inexpensive and I think a lot better looking than the stock blinkies. I have since found something I like better and don't need them anymore. They are pretty much plug and play. The lights have a 3.5mm bullet connectors that plug directly into the stock harness and bolt up to the fender. No cut, no splice.
I did have to put a washer under the base of the light and on the inside of the fender to get the nut on to tighten. The lights are OEM off a CBR250. $20 shipped to to USA address.
Here is a photo of the light installed.
I did have to put a washer under the base of the light and on the inside of the fender to get the nut on to tighten. The lights are OEM off a CBR250. $20 shipped to to USA address.
Here is a photo of the light installed.
Last edited by xeris; 10-18-2013 at 02:19 PM. Reason: add photo and info
Thread
Thread Starter
Forum
Replies
Last Post
Magnus
Classifieds
5
05-29-2014 06:52 PM
johnclopp85
Technical Discussion
5
05-13-2009 07:20 AM
skokievtr
General Discussion
0
05-01-2007 10:11 PM