Joe Rocket leather pants F/S size 34
10-06-2022, 10:04 AM
#2
Junior Member
Squid
Join Date: May 2022
Posts: 25
Update report; it's been 7-8 months since I started the 3rd floor condo living room build. The only area the was not rebuilt is above the oil pan block seam and below the cylinder head. I'm hoping to have fire in the holes in about 2-3 weeks, after she gets moved down the elevator. Still waiting on a front caliper piston that is supposed to be here in a week or so.
10-06-2022, 07:54 PM
#6
Junior Member
Squid
Join Date: May 2022
Posts: 25
Good eye; ya..... it's a screw-up; In my defence when ya take on the whole deal there is bound to be a mistake.
So, I bead blasted the pipes; bad move. Now I'm looking at bare metal so I went the VHT ceramic primer and spray as per instructions on the can. I have little faith that it will hold. Plan is to hook up the CarbTune, set intial at 2 1/2 front and a bit more on the rear on the air screws and run it for the reccommended 10 minutes. I think that it will look like **** after getting to temp. It was a **** up........................
So, I bead blasted the pipes; bad move. Now I'm looking at bare metal so I went the VHT ceramic primer and spray as per instructions on the can. I have little faith that it will hold. Plan is to hook up the CarbTune, set intial at 2 1/2 front and a bit more on the rear on the air screws and run it for the reccommended 10 minutes. I think that it will look like **** after getting to temp. It was a **** up........................
03-05-2024, 06:41 PM
#8
Member
Squid
Join Date: May 2021
Location: Oregon
Posts: 37
Ordered a Scotts Performance stabilizer back in November 2023.
Got a voicemail sometime later saying that shipment would be delayed until about February 2024
Sent an email to their customer service to check up on the order in early Feb: no reply.
Called today (March 5th) and the best date they could give me was "a couple of months" for Honda mounts.
Offered a refund or stay on backorder. said i'd stay on backorder :/
I wonder if they have only like one CNC running components and leave it tooled up for one part until the run is done. frustrating but makes sense.
Then found out my quadlock garmin mount is delayed in transit and the stabilizor is also on backorder.
Riding season 2024 is getting off to a rough beginning and I haven't even started the bike yet, lol
Got a voicemail sometime later saying that shipment would be delayed until about February 2024
Sent an email to their customer service to check up on the order in early Feb: no reply.
Called today (March 5th) and the best date they could give me was "a couple of months" for Honda mounts.
Offered a refund or stay on backorder. said i'd stay on backorder :/
I wonder if they have only like one CNC running components and leave it tooled up for one part until the run is done. frustrating but makes sense.
Then found out my quadlock garmin mount is delayed in transit and the stabilizor is also on backorder.
Riding season 2024 is getting off to a rough beginning and I haven't even started the bike yet, lol
Thread
Thread Starter
Forum
Replies
Last Post
