I have to reassemle the frame whit the engine.

The manual does not say anything about it.

What are the torque of the pins of the frame?
Also, how many shims you have in your chassis? only one that mounts on the left side in the center, right?

 

actually the service manual says quite a bit about it.

look here:

http://www.superhawk996.net/Honda_VT...ice_Manual.pdf

you have to scroll through to find chapter 7 - engine removal installation. has torque values and techniques. the torque values are also listed on page 1-12 in specifications section chapter 1.
they describe special tools from honda. others have made some but its harder to set the torque without the special tools - about $150 from honda total for both you need.

good luck

 

Great! Thanks a lot, I hav'nt see this part in the service manual...