Compression Question
#1
Compression Question
Hello all, I have a question on compression. I have my carbs and valve covers off and decided to do a compression check.
Both cylinders are at 120, not sure if I should do something different. The number is even on both but shouldn't it be higher?
Both cylinders are at 120, not sure if I should do something different. The number is even on both but shouldn't it be higher?
#2
Yes indeed, a lot more than 120 would be good. I'll have to refer to the manual when I get a sec, but definitely higher than that. Could be a lot of reasons but the easy quick test is to add some oil to the cylinder then retest. If you have normal compression with a cap full of oil, you likely need a bore/hone/rings. Make sure you have the throttle wide open when cranking.
AV
AV
#3
I don't recall that I've ever had 2 identical compression readings on an engine, even a fresh rebuild. I might suggest that you use a different gauge and run it again. Most automotive places, AutoZone, etc loan them out for free. Not saying that they are the most accurate, but.
Thread
Thread Starter
Forum
Replies
Last Post