Technical Discussion Topics related to Technical Issues

almost done but i dont know where this tube goes

Old 10-22-2018, 06:12 PM
  #1  
Junior Member
Squid
Thread Starter
 
SuperNewb's Avatar
 
Join Date: Oct 2018
Location: Pennsylvania
Posts: 7
SuperNewb is on a distinguished road
almost done but i dont know where this tube goes

on the tail end of an engine swap on 98 hawk that I'm dropping a 99 motor into, I have a tube that I'm not sure where it goes, I think it doesn't connect to anything like a breather or valve relief but any insight would be appreciated...obviously right crankcase. #14 is the mystery tube
SuperNewb is offline  
Old 10-22-2018, 07:02 PM
  #2  
Senior Member
Back Marker
 
Floyd's Avatar
 
Join Date: Sep 2017
Location: FL
Posts: 197
Floyd is on a distinguished road
Just looked at mine. The hose goes over the starter and then bundles with the other vent/drain hoses.
Its connected to nothing on the other end.
Floyd is offline  
Old 10-22-2018, 07:09 PM
  #3  
Member
Squid
 
superhawk138's Avatar
 
Join Date: Sep 2011
Posts: 32
superhawk138 is on a distinguished road
I first thought it may be a tube from the weep hole on the water pump but not so. Its listed as a Bulk Hose / Vacuum.
superhawk138 is offline  
Old 10-23-2018, 02:23 AM
  #4  
Junior Member
Squid
Thread Starter
 
SuperNewb's Avatar
 
Join Date: Oct 2018
Location: Pennsylvania
Posts: 7
SuperNewb is on a distinguished road
thanks for the responses
SuperNewb is offline  
Old 10-29-2018, 07:08 PM
  #5  
Retired- but not tired!
SuperBike
 
CrankenFine's Avatar
 
Join Date: Aug 2010
Location: Pittsburgh
Posts: 1,478
CrankenFine is on a distinguished road
The later models included a weep hose connector from the water pump. If you have an earlier model is nothing to attach it to.
CrankenFine is offline  
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Mvanriel60
General Discussion
3
09-04-2018 02:51 PM
smokinjoe73
Technical Discussion
18
07-16-2012 06:20 PM
CruxGNZ
Technical Discussion
3
02-20-2011 10:02 AM
clarkwebb
Technical Discussion
2
07-07-2008 09:27 PM
ttenpas
General Discussion
6
04-28-2005 08:09 PM


Thread Tools
Search this Thread
Quick Reply: almost done but i dont know where this tube goes



All times are GMT -7. The time now is 02:53 AM.