929 wheel on rc51 sp1 front end
#2
You'll definitley need to swap the bearings out... I think 929's are 25mm... the RC's are stupid 22mm (I say stupid because every standard bearing kit remover comes with 20mm and 25mm "removers"... of course the RC has to be difficult.)
I'd guess if the rotors bolt up in the right spot, the bearings should be all you need... maybe some spacers at worst.
I'd guess if the rotors bolt up in the right spot, the bearings should be all you need... maybe some spacers at worst.
#4
Whoops.... Yeah, I missed that... (monday mind thing).... the rotors are larger... I though you were using RC rotors on the 929 wheel.... I'd bolt it up and see where everything nets out.... might be close.
You could have new caliper brackets made.. but it's much cheaper to buy a set of rotors... most go in the 100 dollar range used for a set.
You could have new caliper brackets made.. but it's much cheaper to buy a set of rotors... most go in the 100 dollar range used for a set.
Thread
Thread Starter
Forum
Replies
Last Post
inderocker
Classifieds
6
11-02-2009 02:08 PM
inderocker
Everything Else
2
05-29-2009 05:53 AM
Flight_996
Classifieds
13
01-06-2007 04:19 PM