Stroking the Super Hawk
#1
Stroking the Super Hawk
While inside these motors I noticed plenty of room to stroke these guys . Of course a shorter set of Carrilo rods would need be used .
If building a stock stroke 1107cc big bore engine add on top
+ 3mm stroke = 70cc for a total 1177cc engine
+5mm stroke = 116cc for a total 1223cc engine
A big problem is the 158hp Superbike engines were using HRC and Moriwaki billet cranks because the stock crank would not hold up under road race conditions . Stroking a stock crank might just be a good way to build an expensive grenade of an engine and the billet cranks are long long gone .
Oh well , we can dream can't we ?
1107cc is enough anyway . Wanna know how to build that one ? :wink:
If building a stock stroke 1107cc big bore engine add on top
+ 3mm stroke = 70cc for a total 1177cc engine
+5mm stroke = 116cc for a total 1223cc engine
A big problem is the 158hp Superbike engines were using HRC and Moriwaki billet cranks because the stock crank would not hold up under road race conditions . Stroking a stock crank might just be a good way to build an expensive grenade of an engine and the billet cranks are long long gone .
Oh well , we can dream can't we ?
1107cc is enough anyway . Wanna know how to build that one ? :wink:
Thread
Thread Starter
Forum
Replies
Last Post
nativegolf
Modifications - Performance
31
05-19-2007 11:59 PM