I have a complete GSXR front brake setup. I like the GSXR lever, but it does not match the clutch. I'am looking for a similar clutch lever with or without master cyl. swap. I never did like the SH adjusters and, I'd rather not shell out $200+ for a set of Pazzo levers. Any ideas?

 

The standard bore diameter of the Superhawk clutch master cylinder is 14 mm. Maybe there's a Suzuki clutch master cylinder with the same bore diameter. I'm not sure where you could start looking.

 

http://cgi.ebay.com.au/Brake-Clutch-...item3caaaa7b25
Are these any good to you.

 

Theres no VTR1000F on that list. Is the RC51 or RVT the same? I don't think it is, any input?

 

A common swap on a Hawk (NT650) is to put adjustable VFR levers on them. If VTR and VFR levers are the same then maybe NT650 levers will fit the VTR- they are non-adjustable. Give me some time and I will do a check on this. JB

 

Thanks erno those would fit my needs for the brake, need to find a clutch master to fit a bike on the list or interchangeable lever for the VTR. Does any one know if an RC 51 clutch master would work?