Clutch levers
I have a complete GSXR front brake setup. I like the GSXR lever, but it does not match the clutch. I'am looking for a similar clutch lever with or without master cyl. swap. I never did like the SH adjusters and, I'd rather not shell out $200+ for a set of Pazzo levers. Any ideas?
|
The standard bore diameter of the Superhawk clutch master cylinder is 14 mm. Maybe there's a Suzuki clutch master cylinder with the same bore diameter. I'm not sure where you could start looking.
|
Originally Posted by boxdogracing
(Post 257405)
I have a complete GSXR front brake setup. I like the GSXR lever, but it does not match the clutch. I'am looking for a similar clutch lever with or without master cyl. swap. I never did like the SH adjusters and, I'd rather not shell out $200+ for a set of Pazzo levers. Any ideas?
Are these any good to you. |
Originally Posted by erno
(Post 257991)
http://cgi.ebay.com.au/Brake-Clutch-...item3caaaa7b25
Are these any good to you. |
A common swap on a Hawk (NT650) is to put adjustable VFR levers on them. If VTR and VFR levers are the same then maybe NT650 levers will fit the VTR- they are non-adjustable. Give me some time and I will do a check on this. JB
|
Thanks erno those would fit my needs for the brake, need to find a clutch master to fit a bike on the list or interchangeable lever for the VTR. Does any one know if an RC 51 clutch master would work?
|
All times are GMT -7. The time now is 01:03 AM. |
© 2024 MH Sub I, LLC dba Internet Brands