Front turn sigs
Thread Starter
Simi Valley, CA
Back Marker
Joined: Mar 2008
Posts: 182
Front turn sigs
Anyone try these or have a good suggestion:
I tried the Lockhart BULB markers but too much heat is melting the plastic and adhesive.
http://www.cyclegear.com/spgm.cfm?item=MRX_LFH1
I tried the Lockhart BULB markers but too much heat is melting the plastic and adhesive.
http://www.cyclegear.com/spgm.cfm?item=MRX_LFH1
Senior Member
Superstock
Joined: Apr 2007
Posts: 284
From: Warren, NH
I have a set of those. They won't just bolt up and work. You would need to make a block off plate for the hole in the fairing. I scrapped the idea and installed them in the back as extras to go with my intergrated tail light.
Senior Member
Superstock
Joined: Apr 2007
Posts: 284
From: Warren, NH
It is not that the cowl is curved is the problem, the hole for the OEM is larger than the whole light assembly. It fits inside the hole perfect, not around the hole.
Senior Member
SuperSport
Joined: Aug 2007
Posts: 714
From: Fredericksburg, VA
Those are designed for F4i's and other CBR's that don't leave a gaping hole when the stockers are removed. I just got a similar set for the RC and I'm sending them back because it will be nearly impossible to install them and make them look pretty. You would have to remove the fairing to screw them into the plates that you make.
I have Lockhart Phillips LED's on the 'Hawk that are triangular shaped and completely cover the hole. They look good and are bright. I'll probably get another set for the RC as well.
I have Lockhart Phillips LED's on the 'Hawk that are triangular shaped and completely cover the hole. They look good and are bright. I'll probably get another set for the RC as well.
Thread
Thread Starter
Forum
Replies
Last Post
Magnus
Classifieds
5
May 29, 2014 06:52 PM
johnclopp85
Technical Discussion
5
May 13, 2009 07:20 AM
