Need help identifying exhaust
Thread Starter
Member
Squid
Squid
Joined: May 2009
Posts: 78
From: Bremerton WA
Need help identifying exhaust
Not sure what slip on cans these are. They have oval exits and looking down the barrel they are pretty much straight pipes with little restriction. They are extremely loud 
. Are these Jardines? They have a riveted on skin with after market mounts. There are two springs where they attach to the exhaust pipe.
Thanks in Advance,
Dean
. Are these Jardines? They have a riveted on skin with after market mounts. There are two springs where they attach to the exhaust pipe.Thanks in Advance,
Dean
evil man of nothing
MotoGP
Joined: Jan 2006
Posts: 4,517
From: Boynton Beach, FL
Hawk's got it they're low mount Two Bros ovals. They made the small ovals, C2s, and large, C5s. A little hard to tell from the angle but they look like the C5's. I've had several and they usually said it on the endcap, although the older ones may not. Sorry I have no life...
Last edited by captainchaos; Jun 4, 2009 at 08:53 PM.
Senior Member
Superstock
Joined: Jan 2009
Posts: 267
same 2bros i got on mine, they might be knock off tho unless someone put a ridiculous amount of time into covering up the 2 rived holes in the side where the 2bros badge once was
really old pic so much work since then actually this was the day i bought it
really old pic so much work since then actually this was the day i bought it
Thread Starter
Member
Squid
Squid
Joined: May 2009
Posts: 78
From: Bremerton WA
Thanks for the replies they are probably Two Brothers, do they typically have the two springs that connect the cans to the exhaust pipe?. In the huge pile of extra parts that came with my bike there are extra rivets and a drill bit for drilling out rivets. They probably have been reskinned sometime due to rash. There is nothing written on the end caps. I'll update them someday. So there are knock offs floating around?
Thread Starter
Member
Squid
Squid
Joined: May 2009
Posts: 78
From: Bremerton WA
Yes, I believe these are two brothers and not knock offs, the badges were removed and the rivets that hold them are turned toward the inside, just never noticed them before. Thanks for the help everyone, now I can change my signature.
Thread
Thread Starter
Forum
Replies
Last Post
dsevans
Knowledge Base
11
Jan 14, 2009 05:01 AM
