Billet pics
#1
Senior Member
Back Marker
Thread Starter
Join Date: Apr 2006
Location: san luis obispo, ca 93405
Posts: 154
Billet pics
So I have been doing some machining and promised some people some pics so here they are
first couple pics are of my adjustble handle bars, basically a variation of convertibars, a very close variation lol
1st and 2nd pic- finished clamp and bar, bar isnt painted yet but eh whatever, clamp is 1" deep 6061 t6 al and the bar is .083 chromo tig welded
3rd pic- test fitting the design with a rapid prototyped clamp and a pvc handle bar with a 4* offset, was a little twitchy a speed but not bad, just kidding
4th pic- exhaust mounts for my two brothers (TBR) high mounts
5th pic is the led turnsignal housing for my R1, 6 wide angle led's per side, defiently not dot legal but better than nothing
6th pic- offset frame slider minus the peg
7th pic- ITS THE CHEESE
first couple pics are of my adjustble handle bars, basically a variation of convertibars, a very close variation lol
1st and 2nd pic- finished clamp and bar, bar isnt painted yet but eh whatever, clamp is 1" deep 6061 t6 al and the bar is .083 chromo tig welded
3rd pic- test fitting the design with a rapid prototyped clamp and a pvc handle bar with a 4* offset, was a little twitchy a speed but not bad, just kidding
4th pic- exhaust mounts for my two brothers (TBR) high mounts
5th pic is the led turnsignal housing for my R1, 6 wide angle led's per side, defiently not dot legal but better than nothing
6th pic- offset frame slider minus the peg
7th pic- ITS THE CHEESE
#3
Senior Member
Back Marker
Thread Starter
Join Date: Apr 2006
Location: san luis obispo, ca 93405
Posts: 154
Disclaimer: All parts were designed and machined by me, so take it with a grain of salt
Parts were designed in Disaster cam 9.1 and machined on a POS milltronics centurion 7
Parts were designed in Disaster cam 9.1 and machined on a POS milltronics centurion 7
#9
Think you can mock up something like (a variation of course) heli bars, mirror extenders, or some other treat and sell them all to us at rock bottom prices?
Now thats a good idea...
Now thats a good idea...
#11
Senior Member
Back Marker
Thread Starter
Join Date: Apr 2006
Location: san luis obispo, ca 93405
Posts: 154
if i didnt get the material for free the green plastic for the rp'ed parts would cost about $150
The bars above are like heli bars, but much better since they can be adjusted a bunch of different ways
The bars above are like heli bars, but much better since they can be adjusted a bunch of different ways
Thread
Thread Starter
Forum
Replies
Last Post