What size are the screws that hold the air cleaner housing unit to the carbs? They're the screws that connect straight to the carbs under the air funnels. I believe there are 8 total, 4 around each carb. I couldn't find what size they are in the manual nor in any of the threads on here. It's a smaller screw with a small washer. Was needing these as they are non-existent at the moment.

 

https://www.bike-parts-honda.com/pie...IRE+STORM.html

M5 x 12

Try using a JIS screwdriver as Phillips can damage them.

JIS Screwdriver Set - Vessel Megadora P1. P2, and P3 - Rugged Roads

After I buggered up one I replaced mine with stainless hex heads versions with a dab of blue loctite to stop 'em getting sucked into the carb ;-).

A thread gauge and ruler could be a useful addtion to the toolbox to measure bolt thread and length requirements.



Nut & Bolt Thread Gauge Fraction/Metric (BLUE)

 

Thanks, I'll get those this evening. Much much appreciated.
Honestly didn't even think about using calipers. Went a bit blank on that one.

 

I had a complete airbox with screws on the freebies thread for over a month. Even bumped it a couple times, no interest.

It just went out with the trash two days ago...

 

Didn't know there was a freebies thread or I would have tried to pick it up man.

 

Do you still need these or do you have some already?

Today I found eight of these when doing some routine organizing out in the garage.
Turns out I am apparently a hoarder with Alzheimers...

 

No. I went to the local hardware store and found some that were sufficient enough. Much appreciated though!