WTB factory exhaust
Thread Starter
Member
Squid
Joined: May 2008
Posts: 36
I cut then entire back baffle out. I used the hole saw to do it. It looks great, but when I did it, I was under the impression that I would not need to rejet, but I think on my bike I need to. Also I am not finding the information I was hoping for as far as a write up on rejetting. I guess I shoudl state I am a noob when it comes to working on bikes. I bought the superhawk because I wanted something I could work on, but just have not found much information for getting started.
Actually I love the way the debaffled exhaust sounds and would love to keep it that way, but I just dont have the cash to pay the dealer to tune it.
Actually I love the way the debaffled exhaust sounds and would love to keep it that way, but I just dont have the cash to pay the dealer to tune it.
Senior Member
SuperBike
Joined: Sep 2005
Posts: 1,572
From: Buffalo, NY
You might just get by with shimming the needles which isnt a real big job, I still have stock cans but the bike does run better with the shimmed needles - I used a #4 brass washer under each needle with about a .026 thickness - others have tried to stick close to .030 with good results... You can also adjust the pilot jet mixture screws a bit to richen up the low range.
Its your decision of course but if you like the better sound like you say it would be worth a little tinkering...
Its your decision of course but if you like the better sound like you say it would be worth a little tinkering...
I cut then entire back baffle out. I used the hole saw to do it. It looks great, but when I did it, I was under the impression that I would not need to rejet, but I think on my bike I need to. Also I am not finding the information I was hoping for as far as a write up on rejetting. I guess I shoudl state I am a noob when it comes to working on bikes. I bought the superhawk because I wanted something I could work on, but just have not found much information for getting started.
Actually I love the way the debaffled exhaust sounds and would love to keep it that way, but I just dont have the cash to pay the dealer to tune it.
Actually I love the way the debaffled exhaust sounds and would love to keep it that way, but I just dont have the cash to pay the dealer to tune it.
Last edited by RickB; Nov 12, 2008 at 12:45 PM.
Thread
Thread Starter
Forum
Replies
Last Post
