wtb later model coolant temp sender
Thread Starter
Senior Member
Superstock
Joined: Mar 2009
Posts: 277
From: south nj (philly area)
wtb later model coolant temp sender
i need a coolant temp sender from a newer model hawk (the smaller sensor on the tstat housing) its gotta work for the newer guage cluster...
thanks
Anthony
thanks
Anthony
Senior Member
MotoGP
Joined: Mar 2007
Posts: 3,132
From: Phoenix, AZ
Yes, it is. They have the same part number but send different signals. Yruyur and I found that out when we upgraded his bike to the newer cluster.
https://www.superhawkforum.com/forum...cluster-18240/
https://www.superhawkforum.com/forum...cluster-18240/
Thread Starter
Senior Member
Superstock
Joined: Mar 2009
Posts: 277
From: south nj (philly area)
The temp sensor is the same the sender is different it looks the same different signal... there are 2a part numbers 37750-pc1-004 for earlier and 37750-kv3-951 for the later the earlier will read higher on newer cluster and newer one will read lower on older cluster...
Senior Member
MotoGP
Joined: Jul 2010
Posts: 3,871
From: Phoenix, AZ
It's in the thermostat housing (not directly attached to the motor), so it depends on whether or not you switched the thermostat out when you did your motor swap.
Senior Member
MotoGP
Joined: Jul 2007
Posts: 5,066
From: NYC
Ahh ok, I made this mistake before. So the sending unit has to be mated to the dash; if I have the old sender and old dash everything should be normal.
So maniac, I woulda done the swap but it wont work
So maniac, I woulda done the swap but it wont work
Thread
Thread Starter
Forum
Replies
Last Post
8541Hawk
General Discussion
3
Aug 26, 2011 03:35 PM
