ntb a clutch master
#1
Senior Member
Back Marker
Thread Starter
Join Date: Apr 2010
Location: kingsport, tn/ tri cities
Posts: 157
ntb a clutch master
anyone have a clutch master laying around that they could let go off.
bike tipped over and i ended up breaking off the screw that hold on the fluid res.
anyone know if i can get that tiny piece of screw out. can i use a different hydraulic clutch master and make it work?
bike tipped over and i ended up breaking off the screw that hold on the fluid res.
anyone know if i can get that tiny piece of screw out. can i use a different hydraulic clutch master and make it work?
#3
I went through my parts box and I do have one. It's the complete assembly and I think I also have the lever in another baggy. It's very clean, been installed on a Superhawk. I'll take some pics if you would like to see it. It's probably be $130 shipped. Inderocker is the guy to ask here. He's a moderator here, in the parts business and pulls lots of stuff from SoCal. You can PM him here on the forum and tell him what you're looking for. I'm not trying to trade you off but there's a difference between used parts and restoration parts. No offense intended.
#4
If it helps there are about 10 on ebay, this one being the cheapest:
1998 VTR1000F VTR 1000 SUPERHAWK CLUTCH MASTER CYLINDER | eBay
1998 VTR1000F VTR 1000 SUPERHAWK CLUTCH MASTER CYLINDER | eBay
#5
Senior Member
Back Marker
Thread Starter
Join Date: Apr 2010
Location: kingsport, tn/ tri cities
Posts: 157
Thanks for the fast replies. I'm probably going to pick up a cheap one from eBay. I just know that posting on here is the fastest way to get questions answered. Thanks again
#8
Yes you can use a different master, local parts place and pick one from the box.
Or get one from Ebay.. If you buy used, just order the seal rebuild kit at the same time and rebuild the MC from the get go.
Thread
Thread Starter
Forum
Replies
Last Post