Hi guys
Im in the process in finalizing my parts for the swap
I am using cbr1000rr f/wheel,but could not source the correct OD bearing
To fit the cbr wheel and a modified inner spacer
So, I know the rc51 bearing is 2mm wider than the cbr
My question is will the extra 2mm width make a difference to the finished f/end
Or do I make up 2 new front spacers 2mm less each side to counter balance
out the bearing width
Advice would be appreciated

cheers

 

If all the other measurements are the same you can make it up with spacers, the bearings work the same way, no worries mate.

 

Thanks for the reply


cheers