Main Air Jet size???
Thread Starter
Senior Member
Back Marker
Back Marker
Joined: Sep 2011
Posts: 144
From: Sofia, Bulgaria
Main Air Jet size???
Hi, I am trying to build DIY Flo-commander, but i need to know what is the exact size(in mm) of the main air jet
the center jet of the pic
i got a precisious aif flow control valve but it is 1,5mm
but i think it is too small for the purpose, so i may use it for the pilot circuit which is smaller
i can get 2 or 3mm, but need to know what the MAJ size is before make up my mind
i will not double the size of the MAJ because the two carbs will not suck the air at the same time so the end hole will be the air that each carb will get
the center jet of the pic
i got a precisious aif flow control valve but it is 1,5mm
but i think it is too small for the purpose, so i may use it for the pilot circuit which is smaller
i can get 2 or 3mm, but need to know what the MAJ size is before make up my mind
i will not double the size of the MAJ because the two carbs will not suck the air at the same time so the end hole will be the air that each carb will get
Member
Superstock
Joined: Jul 2009
Posts: 285
From: Snohomish, WA.
Ok. My eyes are getting old but these dimentions are P.D.C.
Tubing ID=5mm
Tubing OD=7mm
In my opinion you can probably find better tubing at your hardware store than is supplied, but...
Main Jet Adapter Length=21mm
Main Jet Barbed Portion = 9mm
The adapter OD over the main jet diameter is about 7mm.
The adapter...Kind of blurry pics
Attachment 14860
Attachment 14861
The Flow commander Body Frt/Bck
Good Luck!
Tubing ID=5mm
Tubing OD=7mm
In my opinion you can probably find better tubing at your hardware store than is supplied, but...
Main Jet Adapter Length=21mm
Main Jet Barbed Portion = 9mm
The adapter OD over the main jet diameter is about 7mm.
The adapter...Kind of blurry pics
Attachment 14860
Attachment 14861
The Flow commander Body Frt/Bck
Good Luck!
RUNLEVELZERO #99
SuperBike
Joined: Jan 2007
Posts: 2,218
From: Skokie
Thread
Thread Starter
Forum
Replies
Last Post
