Gear shift reversal?
#2
There is a spline that the shift rod is connected to. You would loosen the bolt holding the arm to the spline, then slide the arm out. Rotate it 180 degrees, then put it back on to the spline.
Check to see that the lever position is where you want it to be, then tighten down on the bolt. Loc-tite is a good idea at that time.
Check to see that the lever position is where you want it to be, then tighten down on the bolt. Loc-tite is a good idea at that time.
Thread
Thread Starter
Forum
Replies
Last Post
tapatio
Classifieds
4
02-02-2008 03:58 PM