Splicing a R1 R/R into the SHawk wiring harness?
#1
Splicing a R1 R/R into the SHawk wiring harness?
I read Tweety's great dissertation on the R1 Mosfet R/R and picked one up off Ebay, also got the pre-wired connectors from Eastern Beaver. But I'm still unsure about which wires from the standard wiring harness need to be spliced/soldered into with the new wires/connectors for the Mosfet R/R.
The Honda wires are 3 yellow/green on the top of the stock connector and 1 red/white and 1 green on the bottom.
The R/R is numbered FH012AA and has 3 male connectors on the left (gray) and 2 male connectors on the right (black).
I know this seems simple to some, but I'm just a simpleton and don't want to foul this up.
Thanks in advance for any help given.
The Honda wires are 3 yellow/green on the top of the stock connector and 1 red/white and 1 green on the bottom.
The R/R is numbered FH012AA and has 3 male connectors on the left (gray) and 2 male connectors on the right (black).
I know this seems simple to some, but I'm just a simpleton and don't want to foul this up.
Thanks in advance for any help given.
#3
you can also check my website for a picture of how it is connected
05-04-11 R1 Regulator Rewiring « Just a Geek On a Bike
05-04-11 R1 Regulator Rewiring « Just a Geek On a Bike
#4
you can also check my website for a picture of how it is connected
05-04-11 R1 Regulator Rewiring « Just a Geek On a Bike
05-04-11 R1 Regulator Rewiring « Just a Geek On a Bike
#5
Thanks guys,
This is a great forum, I expected to get flamed for being a dummy. Even though I read the threads about the R/R swaps on this forum I was still a little confused.
Thanks Again.
This is a great forum, I expected to get flamed for being a dummy. Even though I read the threads about the R/R swaps on this forum I was still a little confused.
Thanks Again.
#7
Thread
Thread Starter
Forum
Replies
Last Post