Dymag wheel fit help
#1
Dymag wheel fit help
For those of you with Dymag experience, any good resources or methods for figuring out what a used set of Dymag wheels originally went to? I picked up a set of cast mag wheels that I might use on my SH or on a CB900F project. But I don't know which bike the wheels are set up for. I took them into a couple of shops and was advised to contact Dymag, which I've done and am waiting for email/call back. On my CB project I may build the front and rear ends around the wheels but for the SH I'd need to convert them. We'll see. Just need to do a little detective work and so help is greatly appreciated!
#2
Does it matter what they were for?
If they don't fit the VTR you will need to make them fit. New spacers and brake rotors will most likely be necessary, and possibly some machining of the hubs as well. I think you need to start measuring them up to see what the differences are.
If they don't fit the VTR you will need to make them fit. New spacers and brake rotors will most likely be necessary, and possibly some machining of the hubs as well. I think you need to start measuring them up to see what the differences are.
Thread
Thread Starter
Forum
Replies
Last Post
salmanilla2000
General Discussion
11
09-24-2008 07:40 PM