Anybody have these?

Where can I get them?

Any info much appreciated.

 

The cheapest way to get them is to find a local bearing house, and take a front and rear wheel bearing in to them. They can match up the exact size with a ceramic bearing. You'll save a lot of money going directly to the distributor.

James

 

I am running them and can attest that the bike in amazingly easy to wheel around.

 

I think we went down this road before....

But....
Are you running full ceramics? or Hybrids?
Are you blessed with decent roads? or do you navigate / ride over and through potholes and expansion joints on a daily basis.

Is this still the first set you installed? Thats what, more than a year now of use,,,? or has it been longer?

 

ceramic hybrids, been running them for years now, and our roads are crap......

 

Thanks

thats what i remembered

So after years of use.... you think the buy in was worth it?

 

"worth it" is a very subjective thing.... would I do it again? yes, but I am a chronic OCMD case too

 

I run the same thing with good results

 

i found that CBR Bearings have them for our bike, front 2 and rear 3 all nice in a set with the rubber seals just have to email them and ask about them
They are ceramic hybrid


CBR Bearing Inc