ISO tool kit for vtr ? anyone ?
Thread Starter
Senior Member
Superstock
Joined: Mar 2005
Posts: 296
From: East Cleveland
ISO tool kit for vtr ? anyone ?
i need to adjust my rear yellow shock.... anyone know where i can buy a VTR1000F tool kit for a 98? or other bikes with the same tools used?
Senior Member
SuperSport
Joined: Mar 2005
Posts: 758
From: Laurel, MD
You want the shock adjustment tool from Motion Pro. It has a 3/8" square drive to fit a socket drive wrench. Use an 18" breaker bar for best results.
Any other aftermarket tool will probably work better than the toolkit tool. And there is always the screwdriver or punch method, if you don't mind hogging it up a little.
Any other aftermarket tool will probably work better than the toolkit tool. And there is always the screwdriver or punch method, if you don't mind hogging it up a little.
Thread Starter
Senior Member
Superstock
Joined: Mar 2005
Posts: 296
From: East Cleveland
Re: ISO tool kit for vtr ? anyone ?
im assuming you mean the large wrench half way down on this link:
http://www.kevinscycleracing.com/tools.htm
then again, i see this small mini one on the page... but i THINK you may need the small tooth on both sides of the tool to adjust the shock, ami wrong? cus the small one on that page doesnt have it.
heres an ebay link of somethin that may work. its for a 95 cbr
http://cgi.ebay.com/ebaymotors/ws/eB...spagename=WDVW
Thread
Thread Starter
Forum
Replies
Last Post
AngryOlaf
Knowledge Base
3
May 25, 2010 09:39 AM
