HELP!!!
#1
HELP!!!
I was hoping that someone out there would be able to taka a picture or two of the adjustable frame/engine bolts so I can get an idea of where mine need to be set. I am building a race bike and someone has cut the spacers on the passenger side of my frame.
Anyway, any pics or even better measurements that will help me align my engine properly would be fantastic. I have the motor hung and swingarm and all but I don't want to try and eyeball the spacing of the engine.
Thanks guys,
Chris
Anyway, any pics or even better measurements that will help me align my engine properly would be fantastic. I have the motor hung and swingarm and all but I don't want to try and eyeball the spacing of the engine.
Thanks guys,
Chris
#6
#7
Mick, I got a manual on nearly every computer in the building and two by wireless. I even own a leather bound issue that has a label - "return to Jesus when finished!" I need to know what frikkin screw he's talking about and where it is! Once I find it on the fiche I can figure out how to get a shot of it.
#8
There are three bolts that hold the engine to the frame if you look at the left side of your frame you will notice a hex head bolt with two flat sides that fit into the adjustable spacer that is threaded into your frame. Even if I could get an idea of how far in one of the three bolts are set I will have a perfect starting point. I'm sorry this is so vague. I know one of the bolts is at the top rear of the front head. But not sure if it is covered by the fairing or not.
Thread
Thread Starter
Forum
Replies
Last Post