A few changes...
07-13-2009, 10:23 AM
#1
Senior Member
Superstock
Thread Starter
Join Date: Feb 2009
Location: Nebraska
Posts: 342
A few changes...
Well I have made a few changes recently, so I figured I'd let anyone who cares to know, know. I will post some pics toight, but I went down a tooth in the front (awesome) built my own subframe (which nobody is going to like haha) I am refoamin and recovering my seat, and I just found out my petcock rebuild kit arrived so I'll be doing that tonight. Hopefully it won't flood out everytime I leave it overnight now... Oh I also bought a car muffler to replace the 2 bros can which now lives in a ditch somewhere... So I've been welding up my 2-1 exhasust. Like I said I'll post some pics tonight, as I'm currently at work.
07-13-2009, 12:47 PM
#3
Senior Member
Superstock
Thread Starter
Join Date: Feb 2009
Location: Nebraska
Posts: 342
it's not as bad as it sounds, it's much shorter than a stock can, and perhaps slightly bigger around, but it is cylindrical like a bike muffler. If you didn't know better you'd think it was a bike muffler. 2" inlet like a stock muffler, the only kind of weird thing is that the outlet is something ridiculous, like 4" or something... but it was only like $50 so until I save up for something better it will do.
07-13-2009, 04:46 PM
#4
I don't need any Meds
Superstock
Join Date: May 2009
Location: West Coast, SoCal Inland
Posts: 265
it's not as bad as it sounds, it's much shorter than a stock can, and perhaps slightly bigger around, but it is cylindrical like a bike muffler. If you didn't know better you'd think it was a bike muffler. 2" inlet like a stock muffler, the only kind of weird thing is that the outlet is something ridiculous, like 4" or something... but it was only like $50 so until I save up for something better it will do.
there is a awesome rat bike build also going on, you should check it out for some ideas to borrow and make into your own.
Thread
Thread Starter
Forum
Replies
Last Post
