WTB: Ft bearing spacer from cbr 929/954/1000
#1
WTB: Ft bearing spacer from cbr 929/954/1000
I am using an rc sp1 front wheel on a set if 954 forks. To do this, I have to swap out the rc bearings and spacer for the cbr parts. I have everything but the spacer... So if anyone has a junk 929, 954, or 1000 wheel laying around that they would be willing to pop the spacer from, I would greatly appreciate it...
#2
The combined depth of the bearing and seal for a 929/954/1000 is less than what the RC uses. So spacers for a 929/954/1000 will be too short, iirc
The RC spacers might be correct for the combo.
The RC spacers might be correct for the combo.
Last edited by xeris; 06-25-2020 at 08:41 PM. Reason: Addition
#3
The external spacers will need a 2mm shim on the right( master) side to center the wheel.... Can't use rc spacers, because they are a different diameter. rc=22 954=25.... I got that covered... I need the spacer inside the wheel... I have 954 bearings, and seal. But I need to take a 954 inner spacer, and cut it down to the 109mm length needed for the rc wheel. This is currently the only thing holding up my swap... Ordered one from Bikebandit, but they have no idea when it might actually ship.... Hoping someone might have something lying around... I am checking motorcycle wreckers, but none I have contacted have one, without me having to buy a whole wheel... If I can't make it happen soon, I might just do that...
#4
Thread
Thread Starter
Forum
Replies
Last Post
2wheelust
Modifications - Performance
2
01-07-2009 04:52 AM