WTB Flush Mount Turn Signals
#1
WTB Flush Mount Turn Signals
Hi,
I am looking for some flush mount turn signals, preferably with a clear/smoked lense (will consider amber, or other). I want them to cover the factory holes completely. Two wire is fine for me (Canadian Hawk has running lights from factory).
I am in Canada, send me a PM if you have something.
Thanks.
I am looking for some flush mount turn signals, preferably with a clear/smoked lense (will consider amber, or other). I want them to cover the factory holes completely. Two wire is fine for me (Canadian Hawk has running lights from factory).
I am in Canada, send me a PM if you have something.
Thanks.
#3
#6
You're in Calgary right? I can't believe Blackfoot can't set you up within your budget. I've got a couple of different pairs of flush signals just collecting dust, but they are so inexpensive new, it's not worth the postage to ship.
#7
http://cgi.ebay.com/ebaymotors/HONDA...1%7C240%3A1318
These are the same as the ones LP makes. Just put them on mine and they are great. Cheap too, less than $25. Cover the holes as well. And they're bright LED's.
These are the same as the ones LP makes. Just put them on mine and they are great. Cheap too, less than $25. Cover the holes as well. And they're bright LED's.
#8
These are the ones I am using. They fit the turn signal hole perfectly with the use of the rubber grommet. Only drawback is that you'll have to use something like "Liquid Nails" to secure it to the back side of the grommet. I used a tail light integrator to make running lights out of them too.
http://cgi.ebay.com/ebaymotors/Honda...1%7C240%3A1318
http://cgi.ebay.com/ebaymotors/Honda...1%7C240%3A1318
Thread
Thread Starter
Forum
Replies
Last Post
johnclopp85
Technical Discussion
5
05-13-2009 07:20 AM
CentralCoaster
Modifications - Cosmetic
10
05-06-2009 09:26 AM
CNI Dawg
Modifications - Cosmetic
1
11-07-2005 10:37 AM