FS VTR carbon frame covers "Y" setion
#1
FS VTR carbon frame covers "Y" setion
Hand made full carbon frame covers set "Y "section, glossy
Perfect fitting, easy mount.
75£ or 114$ - per set including shipping costs - worldwide shipping
Perfect fitting, easy mount.
75£ or 114$ - per set including shipping costs - worldwide shipping
Last edited by jedrek750; 10-04-2015 at 07:31 AM.
#2
Also, what fabric and resin types did you use (prepreg?), number of layers, orientation (i.e., 30/60/90 degrees, repeat?), vacuum bagged prior to cure with temporary bleeder to pre-consolidate, curing temperature and method (under vacuum bag), secondary UV resistant clear finish type and number of coats, etc??
Will you sell via PayPal?
Dziękuję
Last edited by skokievtr; 10-06-2015 at 05:34 AM.
#3
Hello! skokievtr
To mount frame covers to frame I use and prefer good qality two side tape (I use-3M water resist tape). U can also use a engine silicone gasket. Velcro it's a little mistake Covers are perfect fit to frame, no problem with dirt water etc...if someone use vtr as a dirt bike it can be a problem
Frame covers have three layers of high quality carbon fiber-one plain and two twill layers. I use high quality clear resin and UV resistant.
All hand made, I use and sell same quality parts. Payment by PayPal
To mount frame covers to frame I use and prefer good qality two side tape (I use-3M water resist tape). U can also use a engine silicone gasket. Velcro it's a little mistake Covers are perfect fit to frame, no problem with dirt water etc...if someone use vtr as a dirt bike it can be a problem
Frame covers have three layers of high quality carbon fiber-one plain and two twill layers. I use high quality clear resin and UV resistant.
All hand made, I use and sell same quality parts. Payment by PayPal
Thread
Thread Starter
Forum
Replies
Last Post
mikstr
Modifications - Performance
43
02-13-2013 12:51 PM