Ok... So if I throw an rc swingarm and wheel on my bike, how far off will the rear sprocket be? I kinda want to do it, since I already have a wheel... I know the front sprocket is interchangeable with several bikes... One of them being certain year vfr750's .. I have a 16t 10mm offset sprocket for a vfr750... So I know they can be had... (please be a 10mm difference...) Mainly I ask because I might have an sp2 swingarm in the works, and it would be cool to use the wheel I got..

 

Only guy I'm aware that did this was Tweety. Search around here, you'll find the thread.

 

Seems like the captain of chaos has done it as well.

 

https://www.superhawkforum.com/forum...rm-swap-17889/

 

Ok...... Tweety did not use an RC wheel... Some kind of CBR wheel... Trying to read through the whole thing again to see where he mentions which CBR... If it is a 17x6, then I can use the info... 17x5.5 is the same

CaptainChaos is the one I am getting the swingarm from, and he used wheels that were the same as the VTR wheels....

 

Just to clarify I had initially mounted stock SP1 wheels and then Marchesinis also off an RC51 and those are what you see in the pics I posted in the other thread.

 

The chain on the sp1 was in line? Just trying to figure out what will work. I guess I am assuming that if I center a 6.0 in place of a 5.5, that the sprocket will end up farther from centerline. Logic says by about 1/4 inch... But I don't put too much faith in logic...